From: Joel Desaulniers (joeldesaulniers@gmail.com)
Date: Sat Apr 08 2006 - 19:21:51 GMT-3
Hi,
I have a question regarding the routers in my home lab. Currently I have
3620 routers, they have 1 Ethernet interface each and an AUI interface.
I have installed Ethernet transceivers in the AUI ports to have 2
Ethernet connections per router, but I do not see these interfaces at
all in the router configuration.
Also, when I do a show ver, I only see 1 Ethernet interface. Any ideas,
do I have to upgrade anything?
R3#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3620-IK9O3S7-M), Version 12.3(5), RELEASE
SOFTWARE (fc1)
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Mon 27-Oct-03 13:41 by kellythw
Image text-base: 0x60008B00, data-base: 0x618AE000
ROM: System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)
cisco 3620 (R4700) processor (revision 0x81) with 61440K/4096K bytes of
memory.
Processor board ID 19275694
R4700 CPU at 80MHz, Implementation 33, Rev 1.0
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
DRAM configuration is 32 bits wide with parity disabled.
29K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
R3#sh ip int brief
Interface IP-Address OK? Method Status
Protocol
Serial0/0 unassigned YES NVRAM up
up
Serial0/1 10.0.0.25 YES NVRAM up
down
Ethernet0/0 unassigned YES NVRAM administratively
down down
Thanks,
Joel Desaulniers
Network Analyst
CCNP, CCNA
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:56 GMT-3