Which one to believe, Configuration guide or Command reference?

From: sheng li (slilxn@yahoo.com)
Date: Mon Apr 03 2006 - 03:05:52 GMT-3

• Next message: sheng li: "RE: OSPF - Hub & Spoke - Point-to-Multipoint"
• Previous message: Cisco Engineer: "CCIE vs. degree"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I'm panicing seeing conflicting values for dhcp ping
timeout.

On Configuration guide, it reads:
(http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hiad_c/ch10/hipdhcps.htm#wp1101095)
Ping Packet Settings
...
...
By default, the DHCP server waits 2 seconds before
timing out a ping packet.

On Command reference, the same thing is described as
500ms for default:
(http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hiad_r/adr_i1h.htm#wp1174434)
Defaults
500 milliseconds

If I'm asked to double the default then I'll have to
make the tough choise... coins in my pocket.

Your suggestion (other than a dice) will be
appreciated!
-Frank

• Next message: sheng li: "RE: OSPF - Hub & Spoke - Point-to-Multipoint"
• Previous message: Cisco Engineer: "CCIE vs. degree"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:56 GMT-3