From: KSGoh (kianseng.goh@gmail.com)
Date: Sun Apr 02 2006 - 08:27:31 GMT-3
thanks..
that works.. but it won't be permanent..
i would like to findout the way on how to change the baud rate in the boot
loader which make it permanent..
i tried set BAUD 9600
but it doesn't...
but this morning.. when i type set BAUD 15200. it does works... and that's
how i change the baud rate from 9600 to 115200 to recovery my faulty ios..
any more help ?
----- Original Message -----
From: Subhash P
To: KSGoh
Sent: Sunday, April 02, 2006 6:23 PM
Subject: Re: change baud rate
Hi,
Just give speed 9600 under line con 0 and not no speed command if its set to
a speed other than 9600
Regards,
Subhash.
On 4/2/06, KSGoh <kianseng.goh@gmail.com> wrote:
does anyone know where can i find the doc on how to change the baud rate
for
console port in 3560 ?
i did a ios recovery via console port (and i change the speed to 115200,
to
speedup the process)..
after the recover... i tried the same method but everytime when i reboot
the
switch.. the speed always falls back to 9600...
i notice theres a speed 115200 in the line con 0..
Switch(config)#line con 0
Switch(config-line)#no speed
Failed to change line 0's speed
any idea on how to solve this ?
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:56 GMT-3