From: Raśl
Date: Thu Mar 30 2006 - 23:14:40 GMT-3
?
The parameters arent clear for me.
Like David says, how can I control to dampen an interface if it has 6 flaps in
one minue.... It would be nice if someone can explain us how to control that.
Also to control the timers so the interface goes again to the routing table.
Thank you!
________________________________
From: nobody@groupstudy.com on behalf of David Vasek
Sent: Thu 3/30/2006 8:05 PM
To: 'Nick Griffin'; ccielab@groupstudy.com
Subject: RE: Flapping Interface
You can use dampening but I still haven't been able to figure out what the
right parameters are.
Check this out:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hirp_c
/ch20/h_ipevdp.htm
I know that's not the complete answer, but it's a start. I'm definitely open
to ideas, like how to dampen an interface that flaps 6 times in a minute, or
something like that.
-DV
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Nick
Griffin
Sent: Thursday, March 30, 2006 7:48 PM
To: ccielab@groupstudy.com
Subject: Flapping Interface
If your asked to provide a configuration to remove an interface from
participating in exchanging routing information, after a certain number of
interface flaps, what configuration options are available for this?
I'm not aware of any options.
TIA
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:40 GMT-3