From: Vishal Patel (vpatel@accessproviders.com.au)
Date: Tue Mar 21 2006 - 19:19:05 GMT-3
Iam using cisco voip phones and I have 3550 series switches.
Below is my config for a switchport.
interface FastEthernet0/4
description Jahan-desk
switchport trunk encapsulation dot1q
switchport trunk native vlan 606
switchport mode trunk
switchport voice vlan 154
End
606 is my data vlan and 154 is voice vlan
I don't think spanning port fast is enable by default when I config voice
vlan.
Cheers
Vishal
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
david robin
Sent: Wednesday, 22 March 2006 9:10 AM
To: Cisco certification
Subject: Voice vlan
dear all,
I m confused a little with the voice VLAN, as I know the ip phone is
attached to the switch with dot1q trunk, shall we configure sw trunk encap
???
interface fast 0/7
sw trunk encap dot1q
sw access 3
switchport voice vlan 5
!
I dunno if this right or not, I checked in the doc CD but they didnt say to
configure this command, what they mentioned that the port fast is enabled by
default when you configure the voice vlan, and this confuse me more, port
fast is enabled only on access ports ????
please help me about this issue
best regards ,
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:39 GMT-3