From: Chris Broadway (midatlanticnet@gmail.com)
Date: Mon Mar 20 2006 - 12:48:59 GMT-3
Those should only go on the Hub. I have those commands there. When I shift
the config to A Hub to spoke configuration the same type of thing happens,
but the opposite. I see neighbors on the hub, but not on the spokes. I
removed the "ip next-hop-self" command from the hub. The only difference
between the two configs is that the spoke to spoke config replaces the
"tunnel destination" command with the "tunnel mode gre multipoint" command.
Any clues?
-Chris
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:39 GMT-3