From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Fri Feb 17 2006 - 13:31:35 GMT-3
Also, remember to allow the ip route in the bridge.....to allow the
routing through the various vlans.
bridge 1 protocol ieee
bridge 1 route ip
Dave Schulz,
Email: dschulz@dpsciences.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ice Fire
Sent: Thursday, February 16, 2006 9:58 PM
To: 'Venkatesh Palani'; Ice Fire
Cc: ccielab@groupstudy.com
Subject: RE: Dot1q-tunneling
It does work..
Thanks
Ice Fire
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Venkatesh Palani
Sent: Thursday, February 16, 2006 9:46 PM
To: Ice Fire
Cc: ccielab@groupstudy.com
Subject: Re: Dot1q-tunneling
Hi,
This is one way,
trunk do1q between R1 and switch ( aallowing vlans 20 and 10 ) and do
IRB on
the router between these two vlans create a BVI with the required IP
address
and it should work.
Thank you,
venkatesh
On 2/17/06, Ice Fire <fire_ice@verizon.net> wrote:
>
> Guys -
>
> I have a question regarding configuring multiple vlans to one router
port
> with a single address.
>
>
>
> R1
>
> |
>
> |
>
> Sw1 ------- R2
>
> |
>
> |
>
> R3
>
>
>
> R3 is in VLAN 20 with address 172.16.10.3 /25
>
> R2 is in VLAN 10 with address 172.16.10.2 /25
>
> R1 is in both VLANS with address 172.16.10.1 /25
>
>
>
> I know it can be done, but I can't seem to find my lab where I have
done
> this before.
>
>
>
> How can this be configured to work correctly?
>
>
>
> Thanks
>
>
>
>
>
> Ice Fire
>
>
This archive was generated by hypermail 2.1.4 : Wed Mar 01 2006 - 11:28:18 GMT-3