From: CCIEin2006 (ciscocciein2006@gmail.com)
Date: Tue Feb 07 2006 - 22:22:23 GMT-3
How do you use the neighbor remote link address? Where is it applied?
On 2/5/06, xprtofnet <xprtofnet@yahoo.com> wrote:
>
> R1_________r2___________R3
> \ /
> \=====isatap=========/
>
>
>
> R1
> !
> interface Tunnel2
> no ip address
> no ip redirects
> ipv6 address 13::/64 eui-64 <-- eui-64 automatically
> gets the LLA
> tunnel source Serial3/0
> tunnel mode ipv6ip isatap
> end
>
>
> R3
> !
> interface Tunnel5
> no ip address
> no ip redirects
> ipv6 address 13::/64 eui-64 <---do this OR get the
> Link Local address for this interface and put it here.
> tunnel source Ethernet0/0
> tunnel mode ipv6ip isatap
> end
>
>
> Routing over tunnel will require neighbor statement
> neighbor remote-link localaddress
>
>
> --- CCIEin2006 <ciscocciein2006@gmail.com> wrote:
>
> > Hello you IPv6 braniacs,
> >
> > Can someone tell me if RIPng will run over an ISATAP
> > tunnel, or over any of
> > the automatic IPv6 over IPv4 tunnels?
> > As usual, Cisco documentation has no mention of
> > this.
> >
> > Thanks
> >
> >
> _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
>
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
This archive was generated by hypermail 2.1.4 : Wed Mar 01 2006 - 11:28:17 GMT-3