From: Brian (bluvmack@gmail.com)
Date: Thu Jan 19 2006 - 13:26:02 GMT-3
To enable the A/A you have to use multiple contexts and effectively if you
are mirroring your Inside/Outside interfaces you have to either share
interfaces or have two additional physical interfaces. The failover
interface will be in the System context so that will not need to be
duplicated. Also, if you enable mulitple context mode you will need to have
ASR groups for asynchronous routing.
----- Original Message -----
From: "Fernando Rodriguez" <fernanrl@yahoo.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, January 19, 2006 2:02 AM
Subject: OT: Pix active/active failover
> Hi,
>
> First of all, thansk for your time. I have a question
> implementing active/active failover on a pix with 7.0.
> I have two pix 535 with 3 ethernets (inside, outside
> and failover). Until now they were in active/pasive
> but I would like to put them in active/active. Is
> there a way of doing this WITHOUT installing any more
> ethernet cards? Further more, can this be done using
> just one context? I found this info:
>
> http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a008045247e.html#wp1096075
>
> Can I implement it some other way?
>
> Kindest regards,
>
> Fernando
> CCIE#144XX CCNP CCDP
>
>
>
>
> ______________________________________________
> LLama Gratis a cualquier PC del Mundo.
> Llamadas a fijos y msviles desde 1 cintimo por minuto.
> http://es.voice.yahoo.com
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:49 GMT-3