From: Chris Atkins (chris_atkins@Blueyonder.co.uk)
Date: Sat Jan 14 2006 - 06:05:27 GMT-3
Chris
That worked fine, thanks you all for your replys.
Cheers
Chris
----- Original Message -----
From: Chris Lewis
To: Chris Atkins
Cc: ccielab@groupstudy.com
Sent: Friday, January 13, 2006 10:56 PM
Subject: Re: Frame relay DE-bit
PIM should not be marked DE, all other should. You can see the effect by
looking at the show frame-relay pvc output send a few pings, see DE go up,
then enable PIM and it should not increase the counters by the number of PIM
packets (can confirm number of PIM packets with an ACL )
Router1>sho frame pvc
PVC Statistics for interface Serial2/0 (Frame Relay DTE)
Active Inactive Deleted Static
Local 0 0 0 0
Switched 0 0 0 0
Unused 3 0 0 0
DLCI = 122, DLCI USAGE = UNUSED, PVC STATUS = ACTIVE, INTERFACE = Serial2/0
input pkts 0 output pkts 0 in bytes 0
out bytes 0 dropped pkts 0 in pkts dropped 0
out pkts dropped 0 out bytes dropped 0
in FECN pkts 0 in BECN pkts 0 out FECN pkts 0
out BECN pkts 0 in DE pkts 0 out DE pkts 0
out bcast pkts 0 out bcast bytes 0
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
switched pkts 0
Detailed packet drop counters:
no out intf 0 out intf down 0 no out PVC 0
in PVC down 0 out PVC down 0 pkt too big 0
shaping Q full 0 pkt above DE 0 policing drop 0
On 1/13/06, Chris Atkins <chris_atkins@blueyonder.co.uk> wrote:
Hi all
Still bit lost on this, if i could put a sniffer on would. Any sugestions
most
appreciated.
Cheers
Chris
----- Original Message -----
From: Chris Atkins
To: ccielab@groupstudy.com
Sent: Friday, January 13, 2006 2:37 PM
Subject: Frame relay DE-bit
Hi all
Quick question, would the config below ensure that PIM is not marked with
the DE bit set, or should I just have the permit IP any any statement so
only
IP traffic is marked ? bit confused :o)
frame-relay de-list 10 protocol ip list 100
!
access-list 102 deny pim any any
access-list 102 permit ip any any
!
interface Serial0/0
ip address 172.16.23.2 255.255.255.248
encapsulation frame-relay
ip ospf network point-to-point
ip ospf priority 0
frame-relay de-group 10 403
frame-relay map ip 172.16.23.1 403 broadcast
no frame-relay inverse-arp
Thanks in advance.
Chris
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:49 GMT-3