From: Scott Morris (swm@emanon.com)
Date: Tue Jan 03 2006 - 22:14:27 GMT-3
You could use kron to do things like shut and no shut your interface as
well.
http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chap
ter09186a008045592c.html
In the kron policy list, you can specify which user you are logging in as
and do things in config mode as well. You would use the "config-cli" as
part of the option.
Two polcies. One at 8am turns it on, another at 5pm turns it off. Kinda a
festive way to do things! Less complicated IMHO than creating a GRE to go
along with stuff.
Scot
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Brian Dennis
Sent: Tuesday, January 03, 2006 5:31 PM
To: Mike Ollington; ccielab@groupstudy.com
Subject: RE: Bring up an interface at a specific time?
Use a GRE tunnel and have the PPP/T1 link as the backup interface for the
GRE tunnel. When it's time for the PPP/T1 to come up, have a time based ACL
deny the GRE traffic so that the tunnel goes down and the backup kicks in.
HTH,
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Mike
Ollington
Sent: Tuesday, January 03, 2006 2:03 PM
To: ccielab@groupstudy.com
Subject: Bring up an interface at a specific time?
Hello,
Not sure if I'm over thinking this requirement - I have a PPP T1 circuit
that should not be `up' between 5pm and 8am, however, it should be up/up
between 8am and 5pm.
Is there a feature to do this or just a bit of lateral thinking?
Thanks,
Mike
This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:47 GMT-3