From: Guyler, Rik (rguyler@shp-dayton.org)
Date: Fri Dec 30 2005 - 10:52:45 GMT-3
Bill, the Ethernet interface can pull a DHCP address. Also, if two
*identical* routes with identical costs/metrics and administrative distances
are created on the router then the router will load balance across both
routes as it can't prefer one over the other. Here's a link that may help
you figure this out (watch the word wrap):
http://www.cisco.com/en/US/products/sw/iosswrel/ps5413/products_feature_guid
e09186a00801d862d.html
Since this is a CCIE study list, we're not big on giving you direct answers,
only sending you in the right directon. ;-)
Rik
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Bill
Wharton
Sent: Thursday, December 29, 2005 7:23 PM
To: ccielab@groupstudy.com
Subject: Object tracking
I have two internet links terminating at my router. I wish to use object
tracking on it router to figure where packets should be sent. But even
before that, I have a problem which I can't determine if it's a real problem
or not.
Internet link 1 is a T1 link with static IP
Internet link 2 is a cable modem with dynamic IP.
Now, I want toI simply set a static route to my T1 link and want all traffic
to go this way, However, when internet link 2 negotiates an IP address via
DHCP, it too would get pushed down with a default gateway from the ISP. Now
which link would the router send packets over? Do cisco routers discriminate
between a manually added route statement vs. one received via DHCP?
How would the router behave? Also, Ethernet interfaces on cisco routers are
capable of being DHCP clients. Right?
Thank you
This archive was generated by hypermail 2.1.4 : Mon Jan 09 2006 - 07:07:52 GMT-3