From: PhiL (theccie@gmail.com)
Date: Wed Dec 21 2005 - 00:23:24 GMT-3
Can you post your route-maps configs?
On 12/20/05, John Matus <John.Matus@tokiom.com> wrote:
>
> the loopback interface will show as a connected interface on the local
> router, but yes, if you advertise it in ospf and redistribute it into
> eigrp, it will show up on your eigrp neighbors...
>
>
> Regards,
>
> John D. Matus
> Technical Support / PAS
> Fujitsu Consulting
> 626-568-7716
> John.Matus@tokiom.com
>
>
>
> CCIEin2006
> <ciscocciein2006@
> gmail.com> To
> Sent by: lab <ccielab@groupstudy.com>
> nobody@groupstudy cc
> .com
> Subject
> Redistribution question
> 12/20/2005 05:17
> PM
>
>
> Please respond to
> CCIEin2006
> <ciscocciein2006@
> gmail.com>
>
>
>
>
>
>
> I have a router with loopback 0 address 150.1.3.3/24 and advertise that
> network in OSPF with the network 150.1.3.0 0.0.0.255 area 0 command.
> If I then redistribute ospf into eigrp on the same router, should the
> 150.1.3.0 network appear in my eigrp topology table and sent to neighbors?
>
> I don't see that happening. Here is my config:
>
> interface Loopback0
> ip address 150.1.3.3 255.255.255.0
> ip ospf network point-to-point
>
> router ospf 1
> log-adjacency-changes
> redistribute eigrp 100 subnets route-map eigrpin2ospf
> network 150.1.3.0 0.0.0.255 area 0
> network 183.1.0.0 0.0.0.255 area 0
>
> router eigrp 100
> redistribute connected route-map connected
> redistribute ospf 1 metric 1500 1000 255 1 1500 route-map ospfin2eigrp
> network 183.1.123.0 0.0.0.255
> no auto-summary
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Regards,PhiL
This archive was generated by hypermail 2.1.4 : Mon Jan 09 2006 - 07:07:51 GMT-3