Re: hold down a route

From: Chris Lewis (chrlewiscsco@yahoo.com)
Date: Mon Nov 28 2005 - 13:16:32 GMT-3

• Next message: Nawaz, Ajaz: "RE: OSPF doubt"
• Previous message: cacca mucca: "RE: Did not passed the Lab"
• Maybe in reply to: Big guy: "hold down a route"
• Next in thread: Nadeem Zahid \(iszahid\): "RE: hold down a route"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

If you use Rip triggered, entries learned from WAN interfaces are semi-permanent.
   
  You could alos look at no kepalives on interfaces so teh local interface does not go down even if teh attached router re-boots.
   
  Chris

Leigh Harrison <ccileigh@gmail.com> wrote:
  A bit messy, but you could change the timeouts on the routes in rip.

LH

Big guy wrote:

>Hi group..
>
>Is there a way to configure a router to keep a route to disapere from the
>routing table
>when a router boots. I am thinking that I have two routers r1 and r2.. Both
>run rip.. If
>r1 needs a reboot, is it posible to keep connected routes of r1 disapere
>from r2's routing
>table..
>
>Thanks
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html

• Next message: Nawaz, Ajaz: "RE: OSPF doubt"
• Previous message: cacca mucca: "RE: Did not passed the Lab"
• Maybe in reply to: Big guy: "hold down a route"
• Next in thread: Nadeem Zahid \(iszahid\): "RE: hold down a route"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:08 GMT-3