From: Desmond Ong (ongdes@singnet.com.sg)
Date: Sun Nov 27 2005 - 04:52:04 GMT-3
Hi there,
I am configuring port-security on my 3550 switch on fa0/1 and fa0/2.
these ports are connected to R1 and R2 respectively in the same vlan
running hsrp. However, I notice that when I shut down fa0/1, The HRSP
virtual mac address is transfer to R2. and I received the following
error message.
"00:04:59: %PORT_SECURITY-2-PSECURE_VIOLATION: Security violation
occurred, caused by MAC address 0000.0c07.ac01 on port FastEthernet0/2."
Below is my config. Hope to hear from u guys.
Tks!
Des
interface FastEthernet0/1
switchport access vlan 10
switchport mode access
switchport port-security
switchport port-security maximum 2
switchport port-security violation restrict
switchport port-security mac-address sticky
switchport port-security mac-address sticky 0000.0c07.ac01
switchport port-security mac-address sticky 0003.e327.89e0
!
interface FastEthernet0/2
switchport access vlan 10
switchport mode access
switchport port-security
switchport port-security maximum 2
switchport port-security violation restrict
switchport port-security mac-address sticky
switchport port-security mac-address sticky 0000.0c5d
!
!
00:06:32: %PORT_SECURITY-2-PSECURE_VIOLATION: Security violation
occurred, caused by MAC address 0000.0c07.ac01 on port
FastEthernet0/2..7174
!
!
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:08 GMT-3