From: Jian Gu (guxiaojian@gmail.com)
Date: Thu Nov 24 2005 - 16:00:01 GMT-3
How would maniplulating root switch help? obviously the command should be
configured on interface level, how about "spanning-tree vlan 22-23 cost ?"
On 11/24/05, Larry Letterman (lletterm) <lletterm@cisco.com> wrote:
>
> Spanning tree root primary and secondary
>
>
>
> Larry Letterman
> INS-NW-WEST
> Cisco Systems
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Kulcsar Andras Benjamin
> Sent: Thursday, November 24, 2005 9:44 AM
> To: Rajib Khan; ccielab@groupstudy.com
> Subject: RE: switch configuration
>
> Yes, configure bridge priority
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Rajib Khan
> Sent: Thursday, November 24, 2005 4:33 PM
> To: ccielab@groupstudy.com
> Subject: switch configuration
>
>
> Hi Group
>
>
> Could any one please help me with the followings
>
> SW1 ------------ SW2
>
> There are 2 trunk port between sw1 and sw2, I want to send vlan 22,23 via
> one link and 32,33 other link but if one link fails then other link should
> forward all vlans. Is there any way can you achieve this with out using
port
> priority and port cost
>
> Thanks in advance
>
>
> Raj
>
>
>
>
> ---------------------------------
> Yahoo! Personals
> Single? There's someone we'd like you to meet.
> Lot's of someone's, actually. Try Yahoo! Personals
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:07 GMT-3