From: Thomwin Chen (thomwin_chen@yahoo.com)
Date: Mon Nov 21 2005 - 22:28:33 GMT-3
I think the missing part is :
interface ATM1/0.306 point-to-point
pvc 0/306
encapsulation xxxxx <---
protocol ppp dialer
dialer pool-member 1
!
Rgds,
Thomwin
John Matus <John.Matus@tokiom.com> wrote:
did you enable:
pvc 0/16 i
pvc 0/5 q ?
Regards,
John D. Matus
Technical Support / PAS
Fujitsu Consulting
626-568-7716
John.Matus@tokiom.com
George Amen
l.com> To
Sent by: Cisco certification
nobody@groupstudy
.com cc
Subject
10/19/2005 02:07 Lab#8 ATM Not working
PM
Please respond to
George Amen
l.com>
Here's the config
R6----BB1
R6:
username BB1 password 0 CISCO
!
interface ATM1/0.306 point-to-point
pvc 0/306
protocol ppp dialer
dialer pool-member 1
!
interface Dialer1
ip address 54.6.8.6 255.255.255.0
encapsulation ppp
dialer pool 1
ppp authentication pap
ppp pap sent-username ROUTER6 password 0 CISCO
!
Should I be able to ping .254 i.e. BB1 ?
because I cant,,
I did a debug on ppp auth, I dont seem to be getting anything from BB1.
sh atm ilmi-status
Interface : ATM1/0 Interface Type : Private UNI (User-side)
ILMI VCC : (0, 0) ILMI Keepalive : Disabled
ILMI State: UpAndNormal
Peer IP Addr: 54.2.9.100 Peer IF Name: ATM0/1/1
Peer MaxVPIbits: 8 Peer MaxVCIbits: 14
Active Prefix(s) :
47.0000.0000.0000.0000.0000.000a
R6#ping 54.6.8.254
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 54.6.8.254, timeout is 2 seconds:
..
This is my 1st shot at ATM configs, any help would be appreciated.
- GA
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:07 GMT-3