From: steven richards (ccie_2005@hotmail.com)
Date: Sat Nov 19 2005 - 08:43:15 GMT-3
Hello,
I am seeing a match input-interface option that I did not see in the Doc CD.
Does this match only the interface subnet or all traffic going through that
interface ?
Thanks,
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_r/qrfcmd5.htm
R1(config-cmap)#matc ?
access-group Access group
any Any packets
class-map Class map
cos IEEE 802.1Q/ISL class of service/user priority values
destination-address Destination address
discard-class Discard behavior identifier
dscp Match DSCP in IP(v4) and IPv6 packets
fr-de Match on Frame-relay DE bit
fr-dlci Match on fr-dlci
input-interface Select an input interface to match <----
ip IP specific values
mpls Multi Protocol Label Switching specific values
not Negate this match result
packet Layer 3 Packet length
precedence Match Precedence in IP(v4) and IPv6 packets
protocol Protocol
qos-group Qos-group
source-address Source address
R1(config-cmap)#matc inpu
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:07 GMT-3