From: kevin gannon (kevin@gannons.net)
Date: Mon Nov 14 2005 - 10:34:35 GMT-3
Should have added nothing seems to be going into class-default
either
SW1#sh policy-map int f0/13
FastEthernet0/13
Service-policy input: BE111
Class-map: BE111 (match-all)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: vlan 111
Match: class-map match-any BE
Match: ip dscp default
0 packets, 0 bytes
5 minute rate 0 bps
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
On 11/14/05, kevin gannon <kevin@gannons.net> wrote:
> Running a simple config below:
>
> class-map match-any BE
> match ip dscp default
> class-map match-all BE111
> match vlan 111
> match class-map BE
> !
> !
> policy-map BE111
> class BE111
> police 8000 8000 exceed-action drop
> !
> interface FastEthernet0/13
> switchport mode dynamic desirable
> service-policy input BE111
> !
>
> Fas 0/13 is a trunk running ISL auto neogiated. When I do
> a ping from SW2 which is attached via the trunk to the above
> switch I dont get matches. I am pinging from SW2 to another
> device hanging off SW1 and I can see the packets are arriving
> with DSCP 0000 using an ACL on the recieving device.
>
> Any idea why I dont get a match ? I have also tried just doing
> a match on an ACL with permit ip any in it.
>
> Thanks & Regards
> Kevin
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:06 GMT-3