From: bruyere@club-internet.fr
Date: Tue Nov 08 2005 - 12:51:05 GMT-3
Hi,
Do we need to have unused port for the reflector-port on RSPAN ?
Do we need to configure the remote destination vlan of RSPAN on the the
reflector-port ? with switcport mode access and switchport acc vl [remote
vlan #] ?
thx
Rgds
----Message d'origine----
>A: Cisco certification
>De: Mike Flanagan
>Sujet: Trouble configuring RSPAN
>Date: Tue, 8 Nov 2005 08:56:48 -0500
>
> Looking at the doc cd when configuring RSPAN you are to use the
>reflector-port command. I am not seeing this as an option on my
>switch. Is this needed to make this work? I just added the remote-
>vlan instead since that is the only option I had. I am running
>12.1(19)EA1d
>
>
> Thanks,
>
>http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225sec/
>3550scg/swspan.htm
>
>
> SW1#conf t
>Enter configuration commands, one per line. End with CNTL/Z.
>SW1(config)#vlan 101
>SW1(config-vlan)#remo
>SW1(config-vlan)#remote-span
>SW1(config-vlan)#end
>SW1#
>
>SW1(config)#monitor session 1 source interface gigabitEthernet 1/0/1
>both
>SW1(config)#monitor session 1 destination remote vlan 101 ?
>
>
>SW1(config)#$sion 1 destination remote vlan 101 reflector-port
>gig1/0/10
>monitor session 1 destination remote vlan 101 reflector-port gig1/0/10
> ^
>
>_____________________________________________________________________ __
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:05 GMT-3