Re: Inband Management on CSS

From: kevin gannon (kevin@gannons.net)
Date: Thu Nov 03 2005 - 14:02:11 GMT-3

• Next message: Kim Gao: "Re: weird Frame-relay switch problem"
• Previous message: kevin gannon: "Re: Convert Unicast to Multicast"
• Maybe in reply to: Jean Baaklini: "Inband Management on CSS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Below is a URL which shows this type of config:

http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_guide_chapter09186a0080158353.html#wp1138185

Regards
Kevin

On 11/3/05, Jean Baaklini <JEAN@se.ibm.com> wrote:
> Hi All,
>
> I'm trying to find out how to configure inband management on a CSS 11506.
> I couldn't find a solution by reading the cisco doc (I haven't received
> the hardware yet).
> I'm basically looking for a solution similar to inband mgt on a catalyst:
> ex: interface vlan p
> ip address ....
> ip tacacs source-interface vlanp
> snmp-server trap-source Vlanp
> ....
>
> I'd be grateful if anyone who did it could let me know if it's possible.
>
> Thanks,
> JP
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.

• Next message: Kim Gao: "Re: weird Frame-relay switch problem"
• Previous message: kevin gannon: "Re: Convert Unicast to Multicast"
• Maybe in reply to: Jean Baaklini: "Inband Management on CSS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:05 GMT-3