From: Scott Morris (swm@emanon.com)
Date: Tue Oct 25 2005 - 15:41:48 GMT-3
Snapshot routing was for classfull protocols, which RIPng is not...
http://www.cisco.com/warp/public/458/20.html
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
kevin gannon
Sent: Tuesday, October 25, 2005 2:32 PM
To: Edwards, Andrew M
Cc: ccielab@groupstudy.com
Subject: Re: v6 snapshot routing...
Doesnt seem to be in 12.2.15(T16)
R1(config-if)#ipv6 rip TEST ?
default-information Configure handling of default route
enable Enable/disable RIP routing
metric-offset Adjust default metric increment
summary-address Configure address summarization
R1(config-if)#ipv6 rip TEST
Regards
Kevin
On 10/24/05, Edwards, Andrew M <andrew.m.edwards@boeing.com> wrote:
> This might be a stupid question... but, is snapshot routing supported
> with RIPng for v6?
>
> andy
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> --
> This message has been scanned for viruses and dangerous content by
> MailScanner, and is believed to be clean.
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:53 GMT-3