From: Niche (jackyliu419@gmail.com)
Date: Tue Oct 25 2005 - 04:52:13 GMT-3
1. So I guess the configuration is,
spanning-tree vlan x forward-time 4
spanning-tree vlan x max-age 6
2. Sorry in advance if it's due to my understanding to the original question
is wrong.
ip rip triggered
this command is actually make the router send update to it's neighbor when
there is a change in network topology.
I think that's not the original question ask for? Snapshot routing was also
the answer that pop up in my mind cause the question was asking kinda like 1
router be route speaker and 1 router be route listener.
May be I am wrong?
Cheers~
Jacky
On 10/25/05, Javier Tomi <fjtm@tid.es> wrote:
>
> 1. Tunning the STP timers. Remember to do it on the STP root and backup
> root of the VLAN
> 2. Ip rip triggered at interface level
>
> HTH
>
> Javi
>
> Nadeem Zahid (iszahid) wrote:
>
> >1. Let say I want to move a switchport into FWD state under 16 second
> >and yet it should
> > go through all STP states, what comes to your mind?
> > - Portfast? will only go through all states after a switch resets,
> >otherwise will skip 2 states
> > - Tune down the STP timers to minimum for that VLAN?
> >LIS=4+LRN=4+AGE=6
> >Which one sounds better fit to fulfill the requirement?
> >
> >2. R1--------------R2
> > - R1 should only send RIP update when it sees one, otherwise not.
> > What comes to your mind - Snapshot?
> >
> >thanks
> >
> >Nadeem
> >
> >NADEEM ZAHID
> >Cat6500 MPLS & FM DevTest
> >
> >250 West Tasman Drive
> >San Jose, CA-95134 USA
> >IP Phone: 1 (408) 526 5857
> >IP Fax: 1 (408) 527 1325
> >
> >"Life is short - use it...!"
> >
> >_______________________________________________________________________
> >Subscription information may be found at:
> >http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:52 GMT-3