From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Thu Oct 20 2005 - 15:01:47 GMT-3
The 2610s and 2611s can take 64Mb of DRAM, but the problem is
flash not RAM:
Router#show version | include memory|flash
System image file is "flash:c2600-j1s3-mz.122-15.T13.bin"
cisco 2610 (MPC860) processor (revision 0x203) with 56320K/9216K bytes
of memory.
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
You need 32Mb of flash to run the newer images, or you can run
them from RAM via tftp booting. Also the 2620s and 2621s can have 64Mb
of DRAM and 32Mb of flash with the current bootrom. These platforms can
boot the newer 2600XM images from flash:
Router#show version | include (memory|flash)|Bootstrap
ROM: System Bootstrap, Version 12.2(10r)1, RELEASE SOFTWARE (fc1)
System image file is "flash:c2600-js-mz.122-15.T16.bin"
cisco 2620 (MPC860) processor (revision 0x102) with 61440K/4096K bytes
of memory.
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
HTH,
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Hough, Earl
> Sent: Thursday, October 20, 2005 12:48 PM
> To: DP; Ashok Ananda (aananda)
> Cc: Cisco certification
> Subject: RE: ipv6 support!
>
> That image is running c2600-j1s3 is Enterprise Basic, which does not
> have support for OSPFv3. If you have a 2620, you can upgrade the DRAM
> from 32 to 64 and you should be able to get the full IP Plus
12.2.15.T17
> image to work on it. Unfortunately, with the older 2610 and 2611
> (non-XM) you are limited to 32Mb DRAM.
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> DP
> Sent: Thursday, October 20, 2005 1:28 PM
> To: Ashok Ananda (aananda)
> Cc: Cisco certification
> Subject: Re: ipv6 support!
>
> A little off-topic but what rev of code is everyone using for 2600's?
My
> 2500's can run OSPFv3 however my 2600/'s with
> c2600-j1s3-mz.122-15.t17.binjust get returned to the config prompt.
> Anyone else having this issue?
>
>
> DP
>
>
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:51 GMT-3