From: Luis Rueda (luis.rueda@comsat.com.co)
Date: Sun Oct 16 2005 - 05:41:51 GMT-3
Sammer,
There is another way.
Don't forget that EIGRP uses 5 items to calculate metric:
BW, DELAY, MTU, RELIABILITY and also LOAD....
If you bring load to the metric calculation then as soon as the 1.5MBps
PVC becomes loaded, it may be a less preferred route, the metrics in
EIGRP may be changed with the metric weights command inside router
configuration mode.
Luis Rueda
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Edwards, Andrew M
Sent: Friday, October 14, 2005 6:04 PM
To: Khurana, Sameer; ccielab@groupstudy.com
Subject: RE: EIGRP 2 pvc's
If they both go to the same site I would suggest PPP multilink.
Of course, you could opt for EIGRP unequal cost load balancing. If you
have firewalls though I would suggest PPP multilink to minimize out of
sequence packet problems.
HTH
andy
-----Original Message-----
From: Khurana, Sameer [mailto:SKHURANA@amfam.com]
Sent: Friday, October 14, 2005 2:22 PM
To: ccielab@groupstudy.com
Subject: EIGRP 2 pvc's
Hi,
I have a 1.5Mbps PVC and a 640Kbps PVC to a remote site. When the
1.5Mbps PVC becomes full I would like packets to be sent over the
640Kbps PVC.
How might I get this done best... EIGRP? CEF?
Thanks,
Sameer
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:51 GMT-3