From: Nawaz, Ajaz (Ajaz.Nawaz@bskyb.com)
Date: Thu Sep 22 2005 - 09:39:24 GMT-3
The ans to you qtn's can be found by reading the following document:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/1218ea1/3550scg/sw
ethchl.htm
hth
Ajaz Nawaz
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Stefan Grey
Sent: 22 September 2005 13:09
To: ccielab@groupstudy.com
Subject: Etherchannel (channel-protocol pagp command)??
What is the purpose of channel-protocol pagp command???
As I think when we configure Etherchannel on the switch:
interface fa0/1
channel-group mode desiramble <- this command already sets the pagp active
mode.
In which cases the channel-protocol pagp command may be needed could be
used???
As I read it is used to set the pagp mode :((.
The same question for channel-protocol lacp command.
thanks,
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:16 GMT-3