From: Blake Silvester (Blake.Silvester@telecom.co.nz)
Date: Wed Sep 21 2005 - 02:25:57 GMT-3
Greetings all,
I am having some issues with OSPF over frame-relay. I have only begun
studying this topic, so I am sure someone can point me in the direction
of a probably quite simple answer.
I have a frame-relay topology with 4 routers connected through a frame
switch, the hub device has a point-to-point link to another device, and
a point to multipoint link to the other two devices.
All the links are pingable and the routers are all forming adjacencies
are in in full state, however, no routes are being accepted into the
route table. I can see advertised routes in a 'show ip ospf database'
however.
Nothing too fancy configured on the devices, so it's not an access-list
or route-map issue, but somehow routes aren't making it into the routing
table.
I wont bother pasting in config's just yet, but if someone has an
interest and would like to see them, that can certainly be managed,
other than that.... Any suggestions appreciated.
Cheers,
Blake S.
"This communication, including any attachments, is confidential.
If you are not the intended recipient, you should not read
it - please contact me immediately, destroy it, and do not
copy or use any part of this communication or disclose
anything about it. Thank you. Please note that this
communication does not designate an information system for
the purposes of the Electronic Transactions Act 2002."
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:16 GMT-3