From: Lee Donald (Lee.Donald@t-systems.co.uk)
Date: Mon Sep 19 2005 - 07:31:16 GMT-3
Bill,
Exactly where are you pinging to and from ?
Regards
Lee.
-----Original Message-----
From: Bill.McKenzie@bisys.com [mailto:Bill.McKenzie@bisys.com]
Sent: 19 September 2005 11:18
To: ccielab@groupstudy.com
Subject: Encap Failed "Router on a Stick"
I'm having some problems getting this configuration to work. I can't figure
out why on a debug ip packet detail, when I ping to or from this I get
encapsulation failed. When I delete the subinterfaces and assign the IP
address to the physical interface and put the switchport in vlan 263, it is
successful. After staring at my configuration for an hour , I can't see
anything wrong with it. Can someone verify this?
Switch1:
interface FastEthernet0/6
switchport trunk encapsulation dot1q
switchport trunk native vlan 263
switchport mode trunk
R6:
interface Ethernet0/0
no ip address
half-duplex
!
interface Ethernet0/0.6
encapsulation dot1Q 6
ip address 163.1.6.6 255.255.255.0
no cdp enable
!
interface Ethernet0/0.263
encapsulation dot1Q 263 native
ip address 204.12.1.6 255.255.255.0
no cdp enable
Thanks in advance,
Bill
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:15 GMT-3