From: Rajib Khan (rajib56666@yahoo.com)
Date: Sat Sep 17 2005 - 09:05:16 GMT-3
Hi there
I am trying to configure HSRP on the router interface and prot-security on the sw interfaces which connects to HSRP routers. What I have noticed when HSRP chancges its state port-security kicks in and blocks the port. Workaround was to use "standby use-bia".
I am not sure where or not cisco will deduct mark for using "Stadby use-bia" unless they specifically ask to use it in the HSRP question.
Do you guys know any other workaround? Following in my port-security config
switchport access vlan 2
switchport mode access
switchport port-security
switchport port-security maximum 2
switchport port-security violation restrict
switchport port-security mac-address sticky
Thanks in advance
Raj
---------------------------------
Yahoo! for Good
Click here to donate to the Hurricane Katrina relief effort.
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:15 GMT-3