From: Curt Girardin (curt.girardin@chicos.com)
Date: Fri Sep 16 2005 - 20:49:21 GMT-3
Hi,
I recently did a lab that required this, and found that the MTU on each
end of the tunnel was based on the source-interface on each side,
therefore, I had to manually set it (on the tunnel interfaces I think),
using the ip mtu command.
Use debug ipv6 ospf adj on each side and pay special attention to the
MTU reported.
Curt
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Edwards, Andrew M
Sent: Friday, September 16, 2005 7:38 PM
To: ccielab@groupstudy.com
Subject: Re: ipv6 ospf over automatic 6to4 tunnels or v4 compatible v6
tunnels
Does anyone know how to get OSPFv3 to operate correctly over
point-to-multipoint interfaces such as 6to4 tunnels or automatic tunnels
usign ipv4 compatible v6 addresses?
I'm thinking its either A. Not possible or B. Possible but requires
the use of OSPF network types
Now, I've tried various combinations of option B... but to no avail....
Any ideas?
Andy
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:15 GMT-3