From: Muhammad Asif (masif1c383@rogers.com)
Date: Wed Sep 14 2005 - 22:13:18 GMT-3
I guess so..
I haven't done this but that's what I think....
You should be OK with the 2950 as it will be learning two different MAC
addresses from two ports, but the only problem I can think of is from the
routers perspective how its going to route when it will receive information
about the same ip address from two different MAC addresses!
Or there is some magic that this bonding will do to not to confuse the
router :)
HTH
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of John
Smith
Sent: Wednesday, September 14, 2005 7:34 PM
To: Muhammad Asif; ccielab@groupstudy.com
Subject: RE: Question on Linux network bonding and Cat 2950 cfg
Yes, so right now on the cat 2950 I have interfaces for 104, 105, do I need
to make them both 104? lets say 106 and 107 are for heartbeat between 2
other servers, so I won't use them.
Muhammad Asif <masif1c383@rogers.com> wrote:I am no expert in Linux, but the
example in the URL that you give, has a
single IP address configured for all the interfaces along with the bonded
interface, where as you are asking to have 192.168.20.104, 105, 106 and 107
IPs?
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of John
Smith
Sent: Wednesday, September 14, 2005 5:43 PM
To: ccielab@groupstudy.com
Subject: Question on Linux network bonding and Cat 2950 cfg
I'm having some issues putting knowledge into practical use.
If I have a linux server and want to do network bonding on it ( 4 nic's ),
lets say I have a 192.168.20.104, 105, 106 and 107 as IP's. What do I have
to on the Cat to support this?
Here's a link on network bonding...
http://www.novell.com/coolsolutions/feature/15280.html
Anyone have any thoughts?
Many Thanks.
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:15 GMT-3