From: Anh P Tran (anhtran81@optusnet.com.au)
Date: Mon Aug 29 2005 - 07:07:29 GMT-3
Hi,
I believed you need to look at the interface configuration to set the key
for ospf authentication
vTest-Border-02(config-if)#ip ospf ?
<1-65535> Process ID
authentication Enable authentication
authentication-key Authentication password (key)<< simple authentication
cost Interface cost
database-filter Filter OSPF LSA during synchronization and flooding
dead-interval Interval after which a neighbor is declared dead
demand-circuit OSPF demand circuit
flood-reduction OSPF Flood Reduction
hello-interval Time between HELLO packets
lls Link-local Signaling (LLS) support
message-digest-key Message digest authentication password (key) <<< md5
authentication
mtu-ignore Ignores the MTU in DBD packets
network Network type
priority Router priority
resync-timeout Interval after which adjacency is reset if oob-resync
is not started
retransmit-interval Time between retransmitting lost link state
advertisements
transmit-delay Link state transmit delay
Hope this help
Anh Tran
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ali.Huang
Sent: Monday, 29 August 2005 8:02 PM
To: Cisco certification
Subject: area authentication
Hi,group,
I am confused of area authentication of OSPF.
I configure as"area <area-id> authentication" or "area <area-id>
authentication message-digest" commands on routers,but I didn't know
where to find the key?When I issue debug ip ospf adja,I found the
following ,
08:23:59: OSPF: Send with youngest Key 0,
It doesn't affect adjacencies between routers.It seems not work,why?
-- THX. Ali.huang
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:20 GMT-3