From: Zouta oxpf (zouta.oxpf@gmail.com)
Date: Sun Aug 28 2005 - 09:53:51 GMT-3
Agree with Hector, Put the loopback in its own area and use area
range. but watchout, you might then require a virtual link, if the
loopback area is not adjacent to area 0.
ZO
On 8/27/05, Hictor Fernandez <gnakh@telefonica.net> wrote:
> If you could place the loopback in other area and then, area range...
>
> Regards
>
> Hictor
> ----- Original Message -----
> From: "rosy bird" <rosybird@gmail.com>
> To: <ccielab@groupstudy.com>
> Sent: Saturday, August 27, 2005 11:42 PM
> Subject: Advertising Loopaback interface in ospf as /24
>
>
> > Hi all
> > Trying to figure out a way to advertise the loopback interface into
> > ospf as /24 route without using the "ip ospf network" command or
> > redistribute connected.
> >
> > Would really appriciate any ideas on the same.
> >
> > Regards
> >
> > Rosy.
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:20 GMT-3