From: Arun Arumuganainar (aarumuga@hotmail.com)
Date: Thu Aug 25 2005 - 00:08:44 GMT-3
Two way you can do this !!!
1) Configure PPP on your T1 and enable " ppp quality " command to determine
on what error rate you need to shut the line .
2) Configure GLBP instead of HSRP and load balance between the two links .
Pls. note : You use use either one of these or combination of both to
achieve your goals .
Thanks and Regards
Arun
----- Original Message -----
From: "George Lampron" <GLampron@hollandhart.com>
To: <ccieprep@gmail.com>; <ccielab@groupstudy.com>
Sent: Thursday, August 25, 2005 8:01 AM
Subject: OT Re: Real life question
> Eigrp
> Load balance the links then you used both of them all of the time.
>
> --------------------------
> Sent from my BlackBerry Wireless Handheld
>
>
> -----Original Message-----
> From: nobody@groupstudy.com <nobody@groupstudy.com>
> To: ccielab@groupstudy.com <ccielab@groupstudy.com>
> Sent: Wed Aug 24 20:21:39 2005
> Subject: Real life question
>
> Hey guys,
>
> I have a question, maybe someone can help. Is there a way for me to
> shut down one of my T1s and bring up the other link (another T1) from
> a different router to the same site if the active link is congested or
> has high error rate?
>
> I am concerned about congestion. I have HSRP going which is working
> if the active T1 dies but I would like this to happen upon error
> counts exceeding some kind of threshhold.
>
> Any thought would be appreciated.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:20 GMT-3