From: gladston@br.ibm.com
Date: Tue Aug 23 2005 - 17:43:54 GMT-3
Some books show examples mapping the remote link-local IPv6 and Site-local (or Aggregatable Global) IPv6 address on ATM/Frame-Relay.
Tests shows mapping only the remote link-local address is enough when IGP advertises the IPv6 configured on the remote interface.
Any comments appreciated.
Rack2R11#sh run int ATM1/0.1311
interface ATM1/0.1311 multipoint
description PVC
ip address 148.5.100.11 255.255.255.0
pvc 0/200
protocol ip 148.5.100.3 broadcast
protocol ipv6 FE80:148:100::3 broadcast
!
ipv6 address 148:5:100:311::11/64
ipv6 address FE80:148:100::11 link-local
ipv6 ospf network point-to-multipoint
ipv6 ospf 10 area 0
end
Rack2R11#sh ipv6 rou ospf
O 148:5:100:311::3/128 [110/1]
via FE80:148:100::3, ATM1/0.1311
Rack2R11#pi 148:5:100:311::3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 148:5:100:311::3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:20 GMT-3