From: gladston@br.ibm.com
Date: Tue Aug 23 2005 - 13:38:57 GMT-3
Thanks Chris,
Do you think the same apply for the other technologies that will fall off?
(legacy ATM/PPP over ATM, PPP over Ethernet, dial)
Cordially,
------------------------------------------------------------------
Gladston
"Chris Lewis \(chrlewis\)" <chrlewis@cisco.com>
23/08/2005 13:03
To
Alaerte Gladston Vidali/Brazil/IBM@IBMBR, <ccielab@groupstudy.com>
cc
Subject
RE: ATT Bit
I do not believe you can.
The decision to set the ATT bit or not is based off CLNS area
configuration and awareness, there is no consideration given to IP at
that point.
If you see ISIS on the exam between now and when it falls off, it should
be pretty straightforward stuff I'm told.
Chris
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
gladston@br.ibm.com
Sent: Monday, August 08, 2005 11:50 AM
To: ccielab@groupstudy.com
Subject: ATT Bit
This Cisco example set the ATT bit if the CLNS route is present.
Do you know if it is possible to set the ATT bit based on the presence
of a IP route?
=================================
clns filter-set L2_backbone_connectivity permit 49.00aa
route-map check-for-L2_backbone_connectivity
match clns address L2_backbone_connectivity
router isis
set-attached-bit route-map check-for-L2_backbone_connectivity
end
show clns route 49.00aa
==================================
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:19 GMT-3