From: ccie2be (ccie2be@nyc.rr.com)
Date: Fri Aug 12 2005 - 10:59:17 GMT-3
Hi guys,
Can anyone explain what's going on here? When I ping the local end of
tunnel only some of the pings go thru.
Rack1R2#p 141.1.25.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 141.1.25.2, timeout is 2 seconds:
!...!
Success rate is 40 percent (2/5), round-trip min/avg/max = 1/1/1 ms
Rack1R2#r int tun 0
Building configuration...
Current configuration : 173 bytes
!
interface Tunnel0
bandwidth 10
ip address 141.1.25.2 255.255.255.0
ip ospf message-digest-key 1 md5 cisco
tunnel source Ethernet0/0
tunnel destination 141.1.0.5
But, pinging the far side of tunnel goes thru 100% - no problem.
Rack1R2#p 141.1.25.5
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 141.1.25.5, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/8 ms
Rack1R2#
TIA, Tim
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:19 GMT-3