From: noel.thompson@datacraft.co.nz
Date: Mon Jul 25 2005 - 15:48:44 GMT-3
Dave,
This may be too late but you can use the fame-relay interface command,
After you put the dlci on you use the question mark and find other
options,
frame-relay interface-dlci xxx protocol ip x.x.x.x
Cisco recommend that you use this only for remote config using bootp,
but it's a way to make it work?
Noel Thompson
-----Original Message-----
From: Schulz, Dave [mailto:DSchulz@dpsciences.com]
Sent: Tuesday, 26 July 2005 02:47
To: ccielab@groupstudy.com
Subject: Frame Question
I have a lab question that has a multipoint frame terminating at R2 with
two DLCIs going to two different routers. You must disable inverse arp,
and must use sub-interfaces. The last catch on this is ..... You cannot
use the map statement. This makes it so you can only use the
frame-relay interface-dlci command. However, this won't work for
mapping to the IP address at each location. Any ideas on how to make
this one work? Everything on the doc cd for static mapping on a
multipoint requires map statements. Hmmmm.
Dave Schulz,
Email: dschulz@dpsciences.com <mailto:dschulz@dpsciences.com >
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:00:31 GMT-3