From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Mon Jul 04 2005 - 15:08:45 GMT-3
Adam-
You can configure the ilmi pvc (pvc 0/16 ilmi) under the Atm interface. and
then use the the atm ilmi-pvc-discovery command. This will tell you which
pvc's are active. Then, use the show atm ilmi-status command to get the
pvcs and the NSAP. You can then configure the pvc's and remove the previously
two commands. This should do it.
Dave
-----Original Message-----
From: nobody@groupstudy.com
To: ccielab@groupstudy.com
Sent: 7/4/2005 12:07 PM
Subject: Determine NSAP Address
Hello Group:
In the past I basically been a "lurker". I am going to take a more
active role so I will probably asking a lot of questions. My first
question
is How do you determine the NSAP address for the ATM router interface if
you
don't have it from the ATM switch?
Thanks for all your help
Adam
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:00:29 GMT-3