From: Godswill Oletu (oletu@inbox.lv)
Date: Wed Jun 29 2005 - 10:24:48 GMT-3
Pat,
It very much depends on what you want to implement, however in all cases
stay with the industrial standards and run away from all proprietary
implementations either from Cisco side or from the vendor's side.
For a frame relay implementation, make sure your encapsulation on both ends
are the same, offcourse you will not use CISCO because your vendor might not
support it.
LMI type are now auto-discoverable, but you might want to hard code.
I think the standard is still the same on cisco side to defined these
parameters appropriately in either the interface or pvc level as you would
if it were a cisco-to-cisco implementation, the major difference comes in
the value of each of the parameters. It is also better to start from the
vendor router and see the parameters they support and match those parameters
on Cisco's side.
On switching, they are alot, but offcourse you will not want to use ISL
trunk encapsulation.
Timers are also a big area to watch in some implementations, the vendor
might be using timers different from Cisco's and you might have some
glitches with technologies that require these timers to be compatible or the
same at both ends.
In routing, you would not want to implement eigrp or ripv2. Even in your
implementations of ospf, bgp, etc they are some cisco flavors or additions
that you would not want to go into.
Like I said, it really much depend on what you want to implement, there are
other areas of differences eg in multicasting, QoS, ISDN, ATM, etc.
In this field, there are three ways of doing things, the Cisco way, the
Vendors way, the industrial standard way and since all Vendors including
Cisco incorporates the standards (if a standard had been defined), you are
better off staying in the middle.
Good luck!
Godswill Oletu
----- Original Message -----
From: "Pat Chui" <cui666@gmail.com>
To: "Group Study" <ccielab@groupstudy.com>
Sent: Wednesday, June 29, 2005 1:48 AM
Subject: pretend to work with non-cisco routers
> All,
> When asked to work with other vendors' routers, on Cisco routers, Do
> you have to set frame-relay encapsulation type to ietf at both
> interface level and pvc level? or setting it only at interface level
> can take care of pvc level?
> and other than F/R encapsulation, what other area you can think of?
> like using 802.1q instead of isl, etc.
>
> Appreciate your feedback,
> Pat
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:45 GMT-3