RE: dialer remote-name usage

From: ccie2be (ccie2be@nyc.rr.com)
Date: Mon Jun 27 2005 - 17:27:29 GMT-3


Chuck,

Yes, that config shows one usage of the dialer remote-name command.

I also found out that this command is needed if multiple dialer profiles are
configured.

Any more scenario's for this command?

Tim

-----Original Message-----
From: Chuck.South@assurant.com [mailto:Chuck.South@assurant.com]
Sent: Monday, June 27, 2005 3:52 PM
To: ccie2be; Group Study
Subject: Re: dialer remote-name usage

Tim,
Does this config reflect your question? This works;

R1#
!
hostname R1
!
username ROUTER-4 password 0 cisco
!
isdn switch-type basic-ni
!
interface BRI1/0
 no ip address
 encapsulation ppp
 dialer pool-member 1
 isdn switch-type basic-ni
 isdn spid1 0835866101
 isdn spid2 0835866301
!
interface Dialer1
 ip address 14.14.14.14 255.255.255.0
 encapsulation ppp
 dialer pool 1
 dialer remote-name ROUTER-4
 dialer string 8358662
 dialer-group 1
 ppp authentication chap
!

R4#
!
hostname R4
!
username R1 password 0 cisco
!
isdn switch-type basic-ni
!
interface BRI0
 no ip address
 encapsulation ppp
 dialer pool-member 1
 isdn switch-type basic-ni
 isdn spid1 0835866201
 isdn spid2 0835866401
!
interface Dialer1
 ip address 14.14.14.44 255.255.255.0
 encapsulation ppp
 dialer pool 1
 dialer string 8358661
 dialer-group 1
 ppp authentication chap
 ppp chap hostname ROUTER-4
 ppp chap password 0 cisco
!

 

                      "ccie2be"

                      <ccie2be@nyc.rr.c To: "Group Study"
<ccielab@groupstudy.com>
                      om> cc:

                      Sent by: Subject: dialer remote-name
usage
                      nobody@groupstudy

                      .com

 

 

                      06/27/2005 10:41

                      AM

                      Please respond to

                      "ccie2be"

 

 

Hi guys,

I use the dialer remote-name command in this scenario:

R1 isdn R2

If R1 is configured to authen R2 using chap and R2 is configured to use a
host different than its default hostname ie R2 has ppp chap hostname xxx
configured.

Can someone confirm this is correct and complete?

I'm concerned that there might be other occasions where I need to configure
the dialer remote-name command that I'm not aware of.

TIA, Tim



This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:44 GMT-3