NAT for MLPoFR

From: dusth@comcast.net
Date: Fri Jun 17 2005 - 17:38:53 GMT-3

• Next message: Tony Schaffran: "RE: privilage level"
• Previous message: ccie2be: "match protocol"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello all,
Does any one of you know to make NAT work over MLPoFR link? Here is my non-operation configuration:
interface FastEthernet0/0
 ip address 204.12.1.6 255.255.255.0
 ip nat inside
 ip router isis
 duplex auto
 speed auto
 isis circuit-type level-2-only
!
interface Serial0/0
 no ip address
 encapsulation frame-relay
 no ip route-cache
 no ip mroute-cache
 no keepalive
 no fair-queue
!
interface Serial0/0.601 point-to-point
 no ip route-cache
 no ip mroute-cache
 frame-relay interface-dlci 301 ppp Virtual-Template1
!
interface Virtual-Template1
 ip address 54.1.8.6 255.255.255.0
 ip nat outside
 ip router isis
 ppp authentication pap
 ppp chap refuse
 ppp pap sent-username ROUTER6 password 0 CISCO
 isis circuit-type level-1
!
Thanks in advance.
Dustin

• Next message: Tony Schaffran: "RE: privilage level"
• Previous message: ccie2be: "match protocol"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:41 GMT-3