From: Bob Sinclair (bsinclair@netmasterclass.net)
Date: Thu Jun 16 2005 - 13:18:24 GMT-3
Chris,
Combining frame-relay traffic-shaping with MQC-based does not seem to work for
me. When I try to apply the map-class I get this response:
R1(config-subif)#frame interface-dlci 102
R1(config-fr-dlci)#class SHAPE
Remove frame-relay traffic shaping first beforeusing GTS in Modular QoS CLI
It seems to be OK if the policy-map is just policing, for example. But the
IOS does not seem to permit multiple shaping techniques on the same
interface.
HTH,
Bob Sinclair
CCIE #10427, CCSI 30427, CISSP
www.netmasterclass.net
----- Original Message -----
From: Chris Lewis (chrlewis)
To: Bob Sinclair ; Thomwin Chen ; ccielab@groupstudy.com
Sent: Thursday, June 16, 2005 2:10 AM
Subject: RE: MQC-Based FRTS
Bob,
Would you agree that there may be circumstances where even though you
are using MQC, you also need to apply a class map, as some command may
not yet be supported within MQC.
So, in this case one would apply the MQC service-policy under the
map-class configuration, the class then gets applied to a frame
interface or DLCI, depending on configuration, and then the frame-relay
traffic-shaping command is required under the frame interface, even
though MQC is being used.
Chris
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Bob Sinclair
Sent: Wednesday, June 15, 2005 12:23 PM
To: Thomwin Chen; ccielab@groupstudy.com
Subject: Re: MQC-Based FRTS
Thomwin,
No, do not configure the command "frame-relay traffic-shaping" when
doing MQC-based shaping. When doing MQC-based shaping remember that the
"shape average" command automatically sets Be equal to Bc, so set Be
explictly to 0 if the task does not require an excess burst. Also
remember that if you want to shape at the DLCI level, using a map-class
frame-relay, then you must shape class class-default.
HTH,
Bob Sinclair
CCIE #10427, CCSI 30427, CISSP
www.netmasterclass.net
----- Original Message -----
From: Thomwin Chen
To: ccielab@groupstudy.com
Sent: Wednesday, June 15, 2005 1:02 PM
Subject: MQC-Based FRTS
Hi All,
just want to confirm.
to configure MQC-Based FRTS, should I use frame-relay traffic-shaping
command in main interface ?
In CiscoDoc, MQC-Based FRTS don't have frame-relay traffic-shaping
command in main interface ??
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft
/12
2t/122t13/frqosmqc.htm
thanks
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:41 GMT-3