From: Lee Carter (l2carter@yahoo.com)
Date: Sat Jun 04 2005 - 16:31:28 GMT-3
No I am wanting to set the router-ID to 0.0.0.0 not
the area ID. This is strictly a lab thing not that I
would want to do this in the real world.
Thanks,
--- "Etchings, Jay" <EtchingsJ@ally.com> wrote:
> Would you mean using a 32 bit number for the AREA ID
> ie area 0.0.0.0 as
> opposed to area 0?
>
> Regards,
>
> Jay Etchings
>
>
> -----Original Message-----
> From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com] On Behalf Of
> Lee Carter
> Sent: Saturday, June 04, 2005 11:44 AM
> To: CCIE LAB
> Subject: OSPF Router-ID 0.0.0.0
>
> Hi all,
>
> I have read the previous posts and have searched for
> setting an OSPF router-id to 0.0.0.0. However, after
> trying the suggestions I am still unable to actually
> accomplish this task.
>
> What I have done so far is go under the router ospf
> process and type
>
> router-id 0.0.0.0
>
> Then clear ip ospf process (or reboot) and check my
> process ID by one of two says.
>
> On the local router (show ip ospf) or on a neighbor
> router (show ip ospf neighbor) both give me the
> router
> ID of a loopback interface that I have (200.0.0.1)
> and
> not the ID of 0.0.0.0.
>
> The command entered under the router ospf process
> takes without error but does not show up in the
> running configuration and I don't get the usual
> message of (you must clear ospf processes for the
> changes to take affect).
>
> Has anyone actually done this (setting their
> router-id
> ot 0.0.0.0) if so. What version of code were/are you
> running and how did you do it?
>
> I am running 12.3 on a 2610.
>
> Thanks,
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam
> protection around
> http://mail.yahoo.com
>
>
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:40 GMT-3