From: Bob (cciebob@comcast.net)
Date: Sat Jun 04 2005 - 15:58:06 GMT-3
Why would someone want to set the router-id to 0.0.0.0? Router-ids need to
be a unique address for OSPF to run correctly.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Lee
Carter
Sent: Saturday, June 04, 2005 1:44 PM
To: CCIE LAB
Subject: OSPF Router-ID 0.0.0.0
Hi all,
I have read the previous posts and have searched for
setting an OSPF router-id to 0.0.0.0. However, after
trying the suggestions I am still unable to actually
accomplish this task.
What I have done so far is go under the router ospf
process and type
router-id 0.0.0.0
Then clear ip ospf process (or reboot) and check my
process ID by one of two says.
On the local router (show ip ospf) or on a neighbor
router (show ip ospf neighbor) both give me the router
ID of a loopback interface that I have (200.0.0.1) and
not the ID of 0.0.0.0.
The command entered under the router ospf process
takes without error but does not show up in the
running configuration and I don't get the usual
message of (you must clear ospf processes for the
changes to take affect).
Has anyone actually done this (setting their router-id
ot 0.0.0.0) if so. What version of code were/are you
running and how did you do it?
I am running 12.3 on a 2610.
Thanks,
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:40 GMT-3