From: ccie2be (ccie2be@nyc.rr.com)
Date: Wed Jun 01 2005 - 13:22:34 GMT-3
Hi guys,
Here's the problem:
r3 e0/1 <---------------------------------------> e0/1 R4
^ ^
| |
137.1.3.3/24 |
137.1.4.4
I assume this should work the same way as ppp over f/r which also allows 2
different ip subnets over the same physical link. So, I figured pppoe was
the way to go but this isn't working so maybe pppoe isn't the way to do
this. Any thoughts on this approach are welcomed.
I configured pppoe exactly as shown on the Doc-cd.
Here's the config from 1 side. The other side is the same except for ip
address:
vpdn enable
!
vpdn-group 1
accept-dialin
protocol pppoe
virtual-template 1
pppoe limit per-mac 50
interface Ethernet0/1
no ip address
half-duplex
pppoe enable
interface Virtual-Template1
mtu 1492
ip address 137.1.3.3 255.255.255.0
sh vpdn
%No active L2TP tunnels
%No active L2F tunnels
%No active PPTP tunnels
%No active PPPoE tunnels
sh ip int brief
Ethernet0/1 unassigned YES unset up
up
Virtual-Access1 unassigned YES unset up
up
Virtual-Template1 137.1.3.3 YES manual down
down
Virtual-Access2 unassigned YES unset down
down
sh ip route
Gateway of last resort is not set
137.1.0.0/24 is subnetted, 1 subnets
C 137.1.37.0 is directly connected, Ethernet0/0
I get similar output from these show commands on the other side of the link.
I also checked that both ethernet interfaces are connected to the same 3550
and in the same vlan.
Anyone have any ideas?
TIA, Tim
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:40 GMT-3