From: Roy Dempsey (roy.dempsey@gmail.com)
Date: Mon May 30 2005 - 12:26:43 GMT-3
Tim,
From an IOS point of view, I don't think it regards policing as
reserving bandwidth in the same way as its does for CBWFQ or LLQ. It
treats it as more of an absolute limit, with no minimum reservation
A very quick scan of the QoS book seems to confirm this. I tested it
on a router by setting up a couple of classes with policing enabled,
and policed over and above the configured bandwidth, and it worked
fine.
With your config, you won't necessarily be policying at the same time,
but you most definitely might want to police class A anyway.
So the answer appears to be that your config would work.
Roy
On 5/30/05, ccie2be <ccie2be@nyc.rr.com> wrote:
> I'm not positive this is what you're asking but if you want to know the
> difference between rate-limit and police during times when there's not
> congestion, then the answer is the same.
>
> Both rate-limit and police set a maximum amount of bandwidth that can be
> used and this maximum can not be exceeded regardless of whether or not
> there's congestion.
>
> Be aware, however, that when you use MQC, the most bandwidth that can be
> reserved is 75% of interfaces' bandwidth.
>
> This raises an interesting question:
>
> Is the bandwidth specified with the police command in MQC considered
> "reserved" and applicable to this max-reserved-bandwidth value?
>
> IOW, suppose this were the configuration:
>
> policy-map TEST
> class A
> police 500
>
> class B
> police 500
>
> and the bandwidth on the interface is 1000. Will this config work?
>
> TIA, Tim
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Firebat
> Sent: Monday, May 30, 2005 6:39 AM
> To: cisco@groupstudy.com; Cisco certification
> Subject: RATE-LIMIT vs POLICE
>
> Hi,
>
> Can anyone here confirm me? I am thinking that 'RATE-LIMIT OUTPUT' command
> under interface configuration is always on, regardless there is congestion
> in
> outgoing interface. And, 'POLICE' command under class/policy-map
> configuration
> will be activated if and only if there is congestion in outgoing interface.
>
> This thought arise when I face problem to configure router to let Voice
> traffic can consume 99% link bandwidth, when there is no data traffic. But,
> when data traffic flows, the voice traffic get only 50% bandwitdh.
>
> Am I right??
>
> Regards,
> Firebat
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:12:03 GMT-3