From: gladston@br.ibm.com
Date: Sun May 29 2005 - 22:28:52 GMT-3
Hi,
Trying to understand if whatch-timeout is aplicable intercept mode and/or whatch mode.
One book says it should be used for watch mode and other book uses it for intercept mode.
What do you think?
==================
quoted
If Intercept is configured to run in watch mode, configure the amount of time it will wait for a watched connection to an established state before terminating the connection. Use this command to do so:
ip tcp intercept watch-timeout <seconds>
Cisco Network Security Little Black Book
===================
This book shows an example where whatch-timeou is configured for intercept mode:
===================
quoted
ip tcp intercept watch-timeout 20
!Sets the time in seconds (20) for a partially opened connection to complete
!the connection sequence before sending a reset command to the local host.
Cisco. Secure Internet Security Solutions
===================
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:12:03 GMT-3