From: ccie2be (ccie2be@nyc.rr.com)
Date: Thu May 26 2005 - 17:57:49 GMT-3
Hi guys,
I now know how to configure BGP to load-balance between paths learned from
either multiple ebgp peers or from multiple ibgp peers.
maximum-paths # --- for ebgp peers
maximum-paths ibgp # -- for ibgp peers
But, how is load balancing configured when the same route is learned from
both an ibgp and an ebgp peer?
I looked at all the bgp commands available under the bgp process but none
appear to do the trick.
Any ideas?
TIA, Tim
R6(config-router)#bgp ?
always-compare-med Allow comparing MED from different neighbors
bestpath Change the default bestpath selection
client-to-client Configure client to client route reflection
cluster-id Configure Route-Reflector Cluster-id
confederation AS confederation parameters
dampening Enable route-flap dampening
default Configure BGP defaults
deterministic-med Pick the best-MED path among paths advertised from
the neighboring AS
dmzlink-bw Use DMZ Link Bandwidth as weight for BGP
multipaths
fast-external-fallover Immediately reset session if a link to a directly
connected external peer goes down
inject-map Routemap which specifies prefixes to inject
log-neighbor-changes Log neighbor up/down and reset reason
redistribute-internal Allow redistribution of iBGP into IGPs (dangerous)
router-id Override configured router identifier
scan-time Configure background scanner interval
R6(config-router)#bgp best ?
compare-routerid Compare router-id for identical EBGP paths
dampening Enable route-flap dampening
dmzlink-bw Use DMZ Link Bandwidth as weight for BGP multipaths
inject-map Routemap which specifies prefixes to inject
med MED attribute
scan-time Configure background scanner interval
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:12:02 GMT-3