From: ccie2be (ccie2be@nyc.rr.com)
Date: Wed May 18 2005 - 14:08:30 GMT-3
Hi guys,
I tried it again and this time it worked using physical interfaces.
Must have been pilot error or some router anomaly.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ccie2be
Sent: Wednesday, May 18, 2005 12:45 PM
To: Group Study
Subject: ipv6 manual tunnels
Hi guys,
I was just configuring manual tunnels to carry ipv6 traffic. When I used
physical interfaces for the source and destination tunnel endpoints, it
didn't work.
When I changed the tunnel endpoints to Loopbacks, it worked.
Here's the working config for one side of the tunnel:
interface Tunnel14
no ip address
ipv6 address FEC0:0:0:14::7/64
ipv6 rip LAB1 enable
tunnel source Loopback0
tunnel destination 150.7.1.1
tunnel mode ipv6ip
Shouldn't the tunnel work either way?
TIA, Tim
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:58 GMT-3